Avago-technologies Cache Protection for RAID Controller Cards Uživatelský manuál Strana 66
- Strana / 139
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Avago Technologies
- 66 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU08 Unit
2.5.5 Connecting a Remote LSIiBBU08 Unit on the System Chassis to a Board-to-Board Cable
Adapter Card on the RAID Controller
This section describes how to connect a 12-in. cable (sold separately in a Remote Battery Kit) between a remote
LSIiBBU08 unit and a board-to-board adapter card on the MegaRAID SAS 9260-8i RAID controller. You can connect the
LSIiBBU08 unit in the same way to the other MegaRAID SAS RAID controllers that use this iBBU unit.
Perform the following tasks in order:
1. Remove the RAID controller from the computer. See Section 2.5.5.1, Removing the RAID Controller from the Host
Computer, on page 66.
2. Install the board-to-board adapter card on the RAID controller. See Section 2.5.5.2, Installing the Interposer Card
on the Controller, on page 67.
3. Mount the LSIiBBU08 unit to the chassis.
4. Connect the cable between the board-to-board adapter card on the RAID controller and the LSIiBBU08 unit on
the system chassis. See Section 2.5.5.3, Connecting the Cable Between the Interposer Card and the LSIiBBU08
Unit, on page 68.
5. Reinstall the RAID controller. See Section 2.5.5.4, Reinstalling the Controller in the Host Computer, on page 69.
NOTE Because server and workstation chassis vary from vendor to vendor,
no standard mounting option exists that is compatible with the
various system configurations. The LSIiBBU08 battery kit, in
combination with the Remote Battery Kit, includes the battery,
daughter card, cable, and standoff. This combination enables
authorized resellers and chassis manufacturers to customize the
location of the remote battery to provide the most flexibility within
various environments.
2.5.5.1 Removing the RAID Controller from the Host Computer
Follow these steps to remove the RAID controller from the host computer.
1. Turn off the power, and unplug the power cords.
2. Ground yourself, and make sure that the system is grounded.
3. Remove the cover from the computer according to the instructions in the system user’s manual to allow access to
the controller.
4. Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.
5. Place the controller on a flat, clean, static-free surface, and continue with the next procedure.
- Cache Backup Products for 1
- MegaRAID® SAS+SATA 1
- RAID Controllers 1
- Table of Contents 3
- Chapter 1: Introduction 5
- 1.1.4 RAID Cache Module 6
- 1.1.5 CacheVault Modules 6
- 4. Battery Pack Harness 12
- 1. Battery Pack Harness 14
- — MegaRAID SAS 8704ELP 16
- — MegaRAID SAS 8708ELP 16
- — MegaRAID SAS 8888ELP 16
- 2. J1 Connector 17
- Edge of Motherboard 19
- LSIiBBU05 (Top View) 19
- Bracket Scre w 19
- Motherboard 19
- LSIiBBU06 (bottom view) 27
- LSIiBBU06 (top view) 27
- 85024-01 29
- LSIiBBU06 (Top V iew) 30
- Card on a RAID Controller 32
- 3_00719-00 33
- SAS 8708EM2 RAID Controller 34
- 3_00777-00 35
- 3_00705-00 38
- 3_00706-00 39
- 3_00707-00 40
- — MegaRAID SAS 9280-8e 42
- (Rear View) 43
- (Front View) 43
- 85021-03 44
- LSIiBBU07 (Top View) 45
- Bracket Screw 45
- 85021-15 47
- Press Here 48
- 85021-13 51
- 85059-01 54
- 3_00720-00 55
- 3_00721-00 56
- 3_00722-00 57
- 1. J2 Remote Connector 59
- 85065-01 61
- LSIiBBU08 (Top View) 62
- 85065-03 64
- 85039-07 67
- 85039-08 68
- 85085-04 70
- 3_00749-00 73
- 3_00750-00 74
- 3_00751-00 75
- Top View 77
- Bottom View 77
- LSIiBBU09 79
- 3_00891a-00 80
- Controller 81
- Board to Board 82
- Cable Connector 82
- 85083-01 83
- 85083-02 84
- CVPM01 Module 89
- 3_00894-00 93
- 3_00899-00 94
- 3_00895-00 95
- 3_00917-00 96
- Flash Module 98
- (CVFM03) 98
- CacheVault 100
- Power Module 100
- 3_00915-01 101
- 3_00916-01 102
- 3_00918-01 103
- Top View Bottom View 104
- Connector 106
- 3_00895b-00 107
- 3_01657-04 109
- 3_01658-04 110
- 3_01659-04 111
- CacheVault Modules 112
- — Battery information 113
- — Design information 113
- — Capacity information 114
- 3.1.3.3 Display BBU Capacity 118
- The following dialog appears 126
- RAID controllers 134
- Battery Glossary 136
- Avago Technologies 137
- May 2015 137
- Battery Glossary 137
- Revision History 138
Související produkty a manuály pro Hardware Avago-technologies Cache Protection for RAID Controller Cards
(380 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.018 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce